the connection of the exhaust boiler and the fuel boiler is

1.3 Fuel Oil Combustion

A cast iron boiler is one in which combustion gases rise through a vertical heat exchanger and out through an exhaust duct. Water in the heat exchanger tubes is heated as it moves upward through the tubes. Cast iron boilers produce low pressure steam or hot water, and generally burn oil or natural gas.

Learn More

Oil Boiler Exhaust Smell - DoItYourself.com Community Forums

Jan 25, 2019 · connections must enter at a 45-degree connection in the direction of flow and must enter at different elevations, with the smallest vent connection at the highest elevation. MFC vents must not be connected to other manufacturers equipment. The exhaust vent must be pitched upward toward the termination by a minimum of ¼ inch per foot of length.

Learn More

Connecting boilers to SOx scrubbers - Alfa Laval

EXHAUST VENT Clean and dry the boiler connection. DO NOT use primer or cement on the boiler connection. When preparing pipe for installation: Ensure cuts are square. Bevel cut edges by 1/16 - 1/8. Deburr the pipe. Lubricate the gasket. 1. Push the length of pipe into the connection until it touches the bottom of the fitting. 2.

Learn More

MFC Series Boiler Vent and Combustion Air Guide

Exhaust Gas Boilers And Economisers for Marine Machinery

Learn More

Exhaust Systems | Rite Boilers In addition to keeping the

A fuel-heated boiler must provide air to oxidize its fuel. Early boilers provided this stream of air, or draught, through the natural action of convection in a chimney connected to the exhaust of the combustion chamber. Since the heated flue gas is less dense than the ambient air surrounding the boiler, the flue gas rises in the chimney

Learn More

How to Destroy a Boiler -- Part 1

The high efficiency of the condensing boilers results from the fact that heat produced in the condensation process is used to increase heat supply. The exhaust gasses are cooler and hence the maximum condensing happens in the chimney. The condensate then flows along the internal wall of the pressure-tight pipe, and back to the boiler for disposal.

Learn More

Exhaust Gas Boilers And Economisers for Marine Machinery

In the event that the main engine has been operating, with exhaust temperatures above 200 degree C for any length of time, without the circulating pump running, the engine must be slowed down and exhaust temperatures in and out of the exhaust gas boiler to be brought to below 100 Centigrade before starting a circulating pump.

Learn More